Name: Stud finder
as the picture shows. -Material
Metal -Dimensions: 16.5 x 7.6 cm/6.50 x 2.99 inches.
The stud detector can be calibrated anywhere on the wall.
Place the bolt detector against the wall, press the power button, and press the mode switch button to switch to the selected mode. Press the scan key to start the calibration, the signal bar disappears and you hear a beep, the calibration is complete.
Scanning starts again 2-3 seconds after the calibration is successful.
How to use:
Slowly slide the tool across the surface. The arrow and edge indicator will light up, indicating the position of the bolt edge.
When the center of the bolt is found, full bars, arrows, and center indicators are displayed on the LCD screen, and the buzzer sounds.
The AC cable warning detection function can work continuously in any scan mode. When a live AV voltage is detected, the AC warning indicator lights up and protects your safety.
Metal scanning: first scan 1 (or Stud ½ in. 1 ½ inch bolt) in scanning mode, find the position, pick up the stud detector, in the air, press the mode switch button to switch to metal mode, and then repeat the above steps to Determine the location of metal objects faster.
If there is a live wire on the wall, turn off the power.
When scanning a ceiling or wall with an uneven surface, place a thin cardboard on the scanning surface and scan on it.
The color deviation is subject to actual system configuration and slight dimension difference is allowed due to manual measurement.