Product Category:Parking Camera
1/4 CMOS total pixels: 720 * 504 pixels
lens angle: 170 degrees
minimum luminosity: 0 Lux
Android, IOS; ortho image/mirror: optional; housing Material: ABS; Power supply voltage: 12v; Resolution: 720*504; Video signal: digital;
seismic strength: strong
applicable models: general purpose
Software download: scan and download the QR code; open the scan window to scan the product packaging QR code.
Download from website; search on app srore interface for Apple devices; download v-car;
Android devices enter Tencent app search interface; VCAR download;
Tips: interface icon; reversing video viewing WiFi link setting rearview mirror function
Android device use; when installing the software, click (run in the background + start up) and the software will not consume power in the background. When the software runs in the background, the reversing video will pop up automatically when reversing under any interface. When you need to surf the Internet in the car, you can turn off WiFi
After the software is installed, set the static IP 1; connect the v-car name WiFi, 2 enter the WiFi setting interface, remember the two lines under "DHCP" (IP address. Subnet mask), click "static" here, and fill these two lines of numbers under the static Button (IP address. Subnet mask). 3 click back to set successfully. Set static IP, WiFi and 3G, 4G communication at the same time, does not affect the mobile phone access to the Internet.
for Apple uses Siri call: "v-car" to start app;
Product installation (very important, please read it carefully)
1. First of all, turn off the power supply of the vehicle, and do not power on the camera when the power line is not connected properly. 2. Determine the installation position of vehicle camera. The first step is to remove the back cable of the power box;
Reverse lamp positive pole (yellow power line), please connect it to the positive pole.
ACC power positive pole (red power cord), please connect to ACC wiring position on the car.
Negative grounding (black power line), please connect to negative wire harness. Step 2: install the camera, remove the license plate lamp, and connect the camera to the host through the gap of the license plate lamp. Connect the exact position of the three power lines, start the vehicle, adjust the reversing angle, fix the camera with screws, and finally fix it with a tie
English instruction *1
Screw * 2
Note:Light shooting and different displays may cause the color of the item in the picture a little different from the real thing. The measurement allowed error is +/- 1-3cm.