Name: Hardness Durometer
Accuracy: no more than ±1%
Power: 1.5 grid
Working temperature: 0-40 degrees Celsius
Sharp cone point: SR0.1mm
Cone angle of indenter tip: 30 degrees
Total measuring force: 44.5N
Hardness tester size: 3 1/4"L x 2 1/4"W x 1"H
1. The needle is pressed vertically
2. The needle and the sample are in safe contact with the reading within 1 second.
3. Measure the hardness value 5 times at different places (above 6mm apart) and take the average value.
On/off switch: power on and off
H key: keep reading
Zero function: reset reading
Scope of application:
The Shore hardness tester mainly measures the hardness of vulcanized rubber and plastic products. When selecting the model, you can use a ballpoint pen to poke the material (force about 1 kg), type A with indentation, and type D without indentation. The foam material is C type. The measurable hardness range is 0 to 100H (ACD).
1x Hardness Durometer
1.Please allow 0-1cm error due to manual measurement. Please make sure you do not mind before you bid.
2.Due to the difference between different monitors, the picture may not reflect the actual color of the item.