Item type:Oxygen Pump
Cell type: 18650 lithium battery
Nominal voltage/capacity: 3.7V 3600mAH (two 1800mAH in parallel)
Solar panel parameters:
Nominal voltage: 6V
Process: Polycrystalline glass lamination
Size: 130*140mm black plastic frame
Parameters of aeration pump:
Air pump type: DC micro air pump
Rated voltage: 3.0V
Bath sound: less than 60dB
Maximum air flow: 0.9L/min
Minimum air flow: 0.5L/min
Working voltage range: 3.0V－4.25V
Maximum working current: 150+-10MA (high-end); 75+-10MA (low-end).
Quiescent current: less than 500UA
Discharge protection voltage: 3.0V
Charging protection voltage: 4.25V
Whether with light control: without light control
1: High-end working hours when fully charged: 24H
2: Low-end working hours at full power: 48H
3: Low gear Open for 10 seconds and stop for 10 seconds. Full working hours: 96H
4: Shut down
Instructions for use:
Connect the bubble stone to the exhaust hole and put it into the water that needs to be oxygenated. The solar panel faces the sun, and there is no obstruction between the solar battery and the sun. Press the switch and the oxygen pump will start to work. Press the switch repeatedly You can choose different working modes.
1. This product is an electronic product. The aeration device cannot be placed in water, and the diversion hole cannot be blocked.
2. This product is a solar product, and the charging speed is related to the intensity of sunlight. Regularly clean the dirt on the solar cell to improve the charging efficiency.